Earlier we were using hard-coded addresses for MPU setup which
were ensured to be the same as linker script setup. This change
updates the Keil uVision project for Nuvoton Numaker-PFM-M2351
to use the variables exported from the linker script. This ensures
that the MPU setup never goes out of sync with linker script.
Earlier we were using hard-coded addresses for MPU setup which
were ensured to be the same as linker script setup. This change
updates the Keil Simulator demo to use the variables exported
from the linker script. This ensures that the MPU setup does not
go out of sync with linker script.
IAR produces some warnings which can not be fixed in the source code because
then other compilers start generating warnings. We suppressed those warnings
in the project file before. This change moves the warning suppression from
project files to portmacro.h.
Update RISC-V ports so the interrupt stack is set to a known value before the scheduler is started if the interrupt stack is statically defined rather than re-using the main.c() stack.
+ Added xTaskCatchUpTicks() which corrects the tick count value after the application code has held interrupts disabled for an extended period.
+ Updated the xTaskResumeAll() implementation so it uses the new xTaskCatchUpTicks() function mentioned above to unwind ticks that were pended while the scheduler was suspended.
+ Various maintenance on the message buffer, stream buffer and abort delay demos.
+ Change type of uxPendedTicks from UBaseType_t to TickType_t to ensure it has same type as variables it is compared to, and therefore also rename the variable xPendingTicks.
+ Correct spelling mistake within a comment that was common to all the ARMv7-M ports.
The macro taskRESET_READY_PRIORITY checks if the task being removed from the
ready list is the last one and only then resets the top ready priority
by calling portRESET_READY_PRIORITY. If we already know that it is the
last ready task being removed then there is no need to perform the check
again and the macro portRESET_READY_PRIORITY can be called directly. We were
doing the unnecessary check at two places and this commit fixes them.
This commit also increases the time period of check task to ensure that all
the demo tasks get a chance to run before the check is performed.
We had a copy of ARMCM33_DSP_FP_TZ_config.txt file within the project directory
and it used to get outdated with each release of MDK because of non-backward
compatible changes in MDK. This change removes the copy in the project and
instead uses the one shipped with the MDK installation.
Richard Barry
Gaurav Aggarwal
Yuhui.Zheng
Yuhui Zheng